<track id="ftrvp"><strike id="ftrvp"><span id="ftrvp"></span></strike></track>

<dfn id="ftrvp"></dfn>
<track id="ftrvp"></track><span id="ftrvp"></span>
<cite id="ftrvp"></cite>

    <del id="ftrvp"><span id="ftrvp"></span></del>

    <ruby id="ftrvp"><b id="ftrvp"></b></ruby>
    <cite id="ftrvp"><dfn id="ftrvp"></dfn></cite><track id="ftrvp"></track>

    <address id="ftrvp"></address>
    <dfn id="ftrvp"><big id="ftrvp"><ol id="ftrvp"></ol></big></dfn>

    ...
    Home > News

    What is the Structure Features of the Three Cylinder Dryer?

    The three cylinder dryer adopts the "N" type inner rotating ring structure, and horizontally arranges the three cylinder rotary dryer by using the working principle of "internal circulation drying". The machine is mainly composed of front frame, rear frame, sealing device, rotary part, discharging device, transmission device, supporting device, etc. it is horizontally arranged and driven by edge tug. The dryer cylinder is composed of three concentric horizontal inner and outer cylinders. The inner cylinder is composed of straight end and cone, and the middle cylinder is cone-shaped to facilitate the flow of materials; The outer cylinder is a straight cylinder with detachable sealing plates at both ends for easy repair; The length of the cylinder is about 250 / - 35% of that of the single cylinder dryer with the same drying capacity, thus greatly reducing the floor area and the building area of the plant.
    During the operation, the material is fed into the inner cylinder from the silo through the elevator through the blanking pipe, and the hot gas flows downstream from the straight end of the inner cylinder. The material flows into the cone part of the inner cylinder through the advancement of the spiral plate. With the rotation of the cylinder and the dispersion of the lifting plate, the material exchanges with the hot gas while moving forward, enters the middle cylinder from the discharge port of the inner cylinder, and finally enters the outer cylinder. In order to prevent the material blocking at the discharge port, spiral plates are set at both ends of the outer cylinder. At the same time, the lifting plate in the outer cylinder is also arranged at a certain angle, acting like a rotary plate. A small material guide plate is also arranged on the outer wall of the middle and inner cylinder. In the outer cylinder, the material exchanges heat with the hot gas and the outer wall of the middle cylinder through the action of the lifting plate. The dried material is discharged into the flap valve through the discharge port on the outer cylinder, and the waste gas is discharged into the dust collector through the discharge port through the upper part of the discharge hood for dust removal. After drying, the moisture content of the material can reach below 1-0.5%.
     
    ...
    ...
    ...
    ...
    ...
    ...
    揉捏穆桂英双乳三级视频